Profile Box Cranks Spacer - should there be any play?

[Kaner]

So I'm just installing these anniversary cranks into a TA and there is half a millimeter play on both sides of the crank arms. I have put 3 large spacers on the non-drive side and 1 large spacer on the drive side next to the spider.
Should there be any play, there is currently half a millimeter play on each side? Not sure if it will cause a problem or not?
I will put some photos up when I can.

Cheers Ben

[Dark Diggler]

This might help dude, they are exactly the same in terms of the help guide 
http://www.profileracing.com/ht_crank_install.php

[QUADROPHENIA]

tickler, i mean diggler is just so damn bloody helpful, i think hes great 

[Bettyswallocks]

There shouldnt be any play, sounds like you need more spacers

You could wreck the splines if you ride with the arms loose

[Bettyswallocks]

Might be wrong but did the cranks come with any cone spacers?

If not and its for a rider just get a hop up kit, comes with everything you'll need

http://www.alansbmx.com/product_info.php'manufacturers_id=47&products_id=2450

Shop around though cos that seems a bit steep

[Kaner]

This might help dude, they are exactly the same in terms of the help guide 
http://www.profileracing.com/ht_crank_install.php

Cheers Diggler

Good website.  Now installed the extra small washer on the drive side and it has centred the chain and tightened the crank spot on.   

It now has:
Drive side: 1x small washer, 1 x large washer and the spider.

Non Drive Side: 3 x large washers.

Might be wrong but did the cranks come with any cone spacers?

If not and its for a rider just get a hop up kit, comes with everything you'll need

http://www.alansbmx.com/product_info.php'manufacturers_id=47&products_id=2450

Shop around though cos that seems a bit steep

I like the look of the cone spacers, washers just look a bit cheap, might see if I can get some of them, not sure if I want to change the colour of the BB though especially at that price??

Thank for all the help boys