Author Topic: need help removing bearings in BB (Read 917 times)

bmxer123 · « **on:** April 13, 2010, 04:44 PM »

i dont know what type of BB i have, but im wanting to swap the BB from my old frame to my new frame

the reason for this is because im gonna sell the bike on ebay and all i need to do is put the cranks, bearings and chain on. Any special way of doing it? i dont have any of the special tools required hence this topic. Thanks for reading! (Y)

sid1972 · « **Reply #1 on:** April 13, 2010, 04:46 PM »

pictures would be good - is it a one piece crank?

bmxer123 · « **Reply #2 on:** April 13, 2010, 04:51 PM »

aaaaaaaaaaaaaaaaahhhh sorry cant get pics up, i might put some on after i listed the bike (Y) i dno i think its a 3 peice crank and ive did my research and apparently theres a lock bolt or something :\ see i dont know much about the stuff im putting on because i bought the bike on ebay and the guy didnt know too much about it, but yea theres a lock bolt i think, and also the sprocket is still attached along with the spindle, however the cranks are off fine

you got any idea? thanks!

subversion · « **Reply #3 on:** April 13, 2010, 07:38 PM »

clutching at straws without a pic or 2 dude.....

antiquebmx · « **Reply #4 on:** April 13, 2010, 07:45 PM »

mmmm so youve got the crank arms off? you need to take off the lock nut etc, will need 2 big spanners. unscrew all nuts from spindle, then take out. then knock out bearings with hammer and screwdriver from inside through the other side. be careful not to damage anything!!

but im guessing with your description

bmxer123 · « **Reply #5 on:** April 13, 2010, 08:25 PM »

ok theres the pics it would be great if you could identify the lock nut lol i have no idea thanks !

antiquebmx · « **Reply #6 on:** April 13, 2010, 08:41 PM »

fook did you take them with a box with a pin hole in and a stopwatch

it looks like you have two nuts on one side of spindle, you need take off outer nut first